I’m currently using a Steel Kube with an XL banger and insert. Currently I just use the insert by leaving it in the banger. It keeps the banger nice and clean and it’s easy to clean the insert with a torch. Recently I had session with a torch based banger and insert setup where the insert was pre-loaded and dropped in after heat up, which worked really, really well. I’m wondering if anyone has had any experience using their Kube in a similar way. I’m thinking the Glob feature might be useful, too
top of page
bottom of page
I'm using the 25 Banger with and insert at about 550 to 600 and recently just been wondering if I should go up or down??
I've experimented with an "up-temp" technique. When I do this, I start my temperature low, normally around 300*. After the banger has been heated about 50*, I'll drop in my oil and begin my draw. It takes a few draws, but the flavor changes as the temperature rises.
It's definitely fun to play around with the temperature on this device, especially when it's so easy to do.